1. Unpacking Your Fan.
Carefully open the packaging. Remove items from
styrofoam inserts. Remove motor housing and place on
carpet or styrofoam to avoid damage to finish. Do not
discard fan carton or styrofoam inserts should this fan
need to be returned for repairs.
Check against parts inventory that all parts have been included.
2. Parts Inventory.
a. Canopy: 1 piece
b. Hanging bracket (pre-attached to canopy): 1 piece
c. 4 in. down rod and hanging ball (with pin and clip)
1 piece
d. Motor housing: 1 piece
e. Blade arm: 5 pieces
f. Down rod cover:1 piece
g. Blade: 5 pieces
h. Glass shade: 1 piece
i. Light kit fitter: 1 piece
j. Component bags (below components are included)
k. 21in. Down rod
Blade screw: 16 pieces Pull chain fob: 2 piece
Paper washer: 16 pieces Waist beads: 4 pieces
Wood screw: 2 pieces Wire nuts: 3 pieces
Metal washer: 2 pieces
Small lock washer: 2 pieces Safety Bolt: 1 pieces
Balancing weight: 3 pieces
Plastic Clip: 1 pieces Large lock washer: 1 piece
Required bulbs:
Light kit- use – E12, Type B, 40W x 2 (Not Included)
Motor housing-use - E12, Type C, 7W x 4 (Not Included)
WARNING: DO NOT EXCEED INDICATED BULB WATTAGE
NOTE: Your fan is equipped with a wattage limiter, if you exceed the indicated wattage your ceiling fan will not function.
To Next Page
Loading...
