Fan Assembly with down rod. (cont.)
With the hanging bracket secured to the outlet
box and able to support the fan, you are now
ready to hang your fan. Grab the fan firmly with
two hands. Slide down rod through opening in
hanging bracket and let hanging ball rest on the
hanging bracket. Turn the hanging ball slot until it
lines up with the hanging bracket tab.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.
Continue to “Wiring” section for wiring diagram.
8. Wiring.
Important: Be sure outlet box is properly grounded or that
a ground wire (GREEN or bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If you
are
unfamiliar with electrical wiring, or if the house/building
wires are different colors than those referred to in the
instructions, please use a qualified electrician.
When down rod is secured in place on the hanging bracket,
electrical wiring can be made. If you installing the remote control
(sold separately) read Remote Installation Instructions. Then
continue to canopy assembly. Continue reading if remote is not
being installed. (diagram 1) as follows:
Using wire nut provided, connect BLACK and BLUE wires
from fan to BLACK wire from ceiling.
The wires should be spread apart with the grounded
conductor and the equipment grounding conductor on
one side of the outlet box and the ungrounded conductor
on the other side of the outlet box.
Using wire nut provided, connect WHITE wire from fan to
WHITE wire from ceiling. Connect the installing ground wire Green or bare) to the ground wire located on the down
rod end.
The splices, after being carefully made, should be turned
upward and pushed carefully up into the outlet box.
Wrap each wire nut separately with electrical tape as an
extra safety measure.
To Next Page
Loading...
