709243D (Replaces 709243C)
cancer.
Specifications & illustrations subject to change without notice or incurring obligations (10/15).
O’Fallon,MO,©NortekGlobalHVACLLC2015.AllRightsReserved.
Electrical connections tight? YES NO
Line voltage polarity correct? YES NO
Supply Voltage: ________________________________ VOLTS
Has the thermostat been calibrated? YES NO
Is the thermostat level? YES NO
Is the heat anticipator setting correct? YES NO
Gas Type: (circle one)
Natural
Gas
Propane
Gas pipe connections leak-tested? YES NO
Gas Line Pressure: ........................................................ (in - W.C.)
Installation Altitude:............................................................(FT.)
Deration Percentage: ......................................................... (%)
Furnace Input:....................................................................(Btuh)
Supply Air Temperature: ................................................... (° F)
Return Air Temperature: ...................................................(° F)
Temperature Rise: ............................................................(° F)
Is there adequate fresh air supply
for combustion & ventilation?
YES NO
Vent free from restrictions? YES NO
Filter(s) secured in place? YES NO
Filter(s) clean? YES NO
Flue connections tight? YES NO
Is there proper draft? YES NO
It is your responsibility to know this product better than your customer.
This includes being able to install the product according to strict
safety guidelines and instructing the customer on how to operate
and maintain the equipment for the life of the product. Safety should
always be the deciding factor when installing this product and us-
ing common sense plays an important role as well. Pay attention to
all safety warnings and any other special notes highlighted in the
manual. Improper installation of the furnace or failure to follow safety
warnings could result in serious injury, death, or property damage.
These instructions are primarily intended to assist qualified individuals
experienced in the proper installation of this appliance. Some local
codes require licensed installation/service personnel for this type of
equipment. Please read all instructions carefully before starting the
installation.Returntheseinstructionstothecustomer’spackagefor
future reference.
CITY: STATE:
UNIT MODEL #
UNIT SERIAL #
Unit Installed Minimum clearances
per Table 1, (page 6)?
YES NO
CITY: STATE:
Hasthe owner’sinformation been
reviewed with the customer?
YES NO
Has the Literature Package been
left with the unit?
YES NO
To Previous Page
