Intex 26339EH - Page 12

118
PO
SAVE THESE INSTRUCTIONS
(118PO) ULTRA XTR™ POOLS ENGLISH 7.5” X 10.3” PANTONE 295U 05/13/2020
English
Page 11
POOL SETUP
(
continued
)
YoumayhavepurchasedthispoolwiththeIntexKrystalClear™filterpump.Thepumphasitsown
separate set of installation instructions. First assemble your pool unit and then set up the filter pump.
Estimatedassemblytime45-60min.(Notetheassemblytimeisonlyapproximateandindividualassembly
experiencemayvary.)
1. Liner preparation
• Findaflat,levellocationthatisfreeandclearofstones,branchesorothersharpobjectsthatmay
puncture the pool liner or cause injury.
• Openthecartoncontainingtheliner,joints,legs,etc.,verycarefullyasthiscartoncanbeusedtostore
the pool during the winter months or when not in use.
• Takeoutthegroundcloth
(7)
(optional)andspreaditover
the cleared area. Then, take out the liner
(5)
and spread
 itoutoverthegroundcloth,withthedrainvalvedirected
 towardsthedrainingarea.Placethedrainvalveawayfrom
the house. Allow the sun to warm up the liner before
inserting the beams
(4)
intothesleeveopenings.
IMPORTANT: Always set up the pool unit with at least
2 persons. Do not drag the liner across the ground as
this can cause liner damage and pool leakage (see
drawing 1).
• Duringthesetupofthispoolliner,pointthehoseconnectionsoropeningsinthedirectionoftheelectric
 powersource.Theouteredgeofthepoolshouldbewithinreachofthepump’selectricalconnection.
2. Frame assembly
• Theframepool’slegs
(2)
and beams
(4)
fall into two groups. The smaller
 diametersaretheverticallegs.Boththeselegsandbeamsfitintothe
T-joints
(1)
.
NOTE: Sprinkle some talcum powder over the horizontal beams
before sliding them into the pool liner sleeve. This will make
removal of the beams from the liner easier during the disassembly
of the pool.
• Startingatanylocation,butalwaysworkinginthesamedirection,push
 thehorizontalbeamintothesleeve
(see drawing 2.1)
. Once the beam
is centered take one of the T- joints
(1)
, snap the joint to one end of the
beam by aligning the hole and the spring-loaded pin. Repeat this
 procedureinacircularfashionuntilallthebeamsandjointshavebeen
connected
(see drawing 2.2)
.
The last joint connection may be difficult to complete, but can be
easily done by simultaneously raising this last joint and beam
more than 2 inches (5 cm), and connect the beam to the joint while
lowering these pieces to their normal position. The joint will slide
into the beam (see drawing 2.3). Make sure the last joint is fully
assembled before proceeding to assembling the legs.
1
5
2.1
2.3
1
2.2