EasyManua.ls Logo

Intex 26339EH - General Aquatic Safety Guidelines

Intex 26339EH
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
118
PO
SAVE THESE INSTRUCTIONS
(118PO) ULTRA XTR™ POOLS ENGLISH 7.5” X 10.3” PANTONE 295U 05/13/2020
English
Page 12
POOL SETUP
(
continued
)
IMPORTANT
Before allowing anyone to use the pool, hold a family meeting. Establish a set of rules that
include, at a minimum, the important safety rules and general aquatic safety information in this
manual. Review these rules on a regular basis and with all users of the pool including guests.
The installer of the vinyl liner shall affix on the original or replacement liner, or on the pool
structure, all safety signs in accordance with the manufacturer’s instructions. The safety signs
shall be placed above the water line.
• Nextslidetheverticallegsintothebeltlooplocatedinthemiddleof
the pool liner. Carefully slide the leg into the belt loop and insert the
topofthelegintothebottomofthejoint.Snapthelegintojoint’s
holesbyaligningtheholeandthespring-loadedpin.Attachtheleg’s
end cap
(3)
to the bottom of the leg
(see drawing 3)
.
• Grabtheframepool’stopbeamsin2–3locationsand"shake"the
pooltobesureallthejoints,legsandbeams"fitintoeachother".
• Pullgently,inanoutwarddirection,thebottomofthelegmaking
surethelegisverticalandperpendiculartothelevelground.
•
If pool was purchased with a filter pump, read the Krystal Clear™ Filter Pump Manual first and
then proceed to next installation step.
3. Filling of the pool
• Beforefillingthepoolwithwater,ensurethatthedrainpluginsidethepoolisclosedandthatthedrain
capontheoutsideisscrewedontightly.Fillthepoolwithnomorethan1inch(2.5cm)ofwater.Check
toseewhetherthewaterislevel.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely level. Setting up
the pool on unlevel ground will cause the pool to tilt resulting in the sidewall material bulging and
a potential collapse of the pool. If the pool is not completely level, you must drain the pool, level
the area or move the pool to a different area that is level, and re-fill the pool, following the above
directions.
• Smoothoutthebottomlinerwrinkles(frominsidethepool)bypushingoutwherethepoolfloorandpool
sidesmeet.Or(fromoutsidepool)reachunderthesideofthepool,graspthepoolfloorandpullinan
outwarddirection.Ifthegroundclothiscausingthewrinkles,have2peoplepullfromoppositesidesto
removeallwrinkles.Usetheproperlyassembledpoolladderwhenenteringorexitingthepoolduringthis
process.
• Fillthepoolwithwateruptojustbelowthesleeveline
(see
drawing 4)
.
4
.
Posting
aquatic safety signs
SelectahighlyvisibleareanearthepooltoposttheDanger
NoDivingorJumpingsignincludedlaterinthismanual.
3
3
WATERLEVEL
4

Related product manuals