73-1
(73-1) AP619RL REMOTE CONTROL BUILT-IN ELECTRIC PUMP ENGLISH 4.875” X 7.25” 07/14/2011
73-1
(
73-1) AP619RL REMOTE CONTROL BUILT-IN ELECTRIC PUMP ENGLISH 4.875” X 7.25”
07/14/2011
READ AND SAVE THESE INSTRUCTIONS
Page 1
READ AND SAVE THESE INSTRUCTIONS
Page 2
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
INTEX
®
OWNER'S MANUAL
Built-in Fast-Fill™ Electric Pump
with Remote Control
Model AP619RL 110 – 120 V~ 60 Hz 1.0 A
073-1**-R0-1207
INFLATION
1. Make sure the "2 in 1" valve is securely closed. See Fig (1).
2. Plug in the AC line cord into an AC electrical outlet. See Fig (2).
3. Open the foam vacuum valve on the corner of the sleeping surface of bed. See Fig (3).
FIG (2)
110 – 120 V
220 – 240 V
√
NOTE: Drawings for illustration purpose only. May not reflect actual product. Not to scale.
To reduce the risk of burns, fire, electric shock, or injury to persons:
• NEVER PLACE AN INFANT TO SLEEP ON AIR MATTRESSES.
• Never introduce any flammable substance into the inflatable airbed, such as aerosol tire repair products, as it
may ignite or explode.
• For indoor household use only.
• Unplug from outlet before putting on or taking off parts.
• Close supervision is necessary when this furnishing is used by, or near children, invalids, or disable persons.
• Use this furnishing only for its intended use as described in these instructions. Do not use attachments not
recommended by the manufacturer.
• Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
• This is not a toy. Children must not be left unattended when using the airbed.
• Keep the storage bag away from babies and children. The storage bag is not a toy. When not in use, fold the
bag and put it away out of the reach of children.
• Do not walk, stand on or jump on or use the airbed as a trampoline.
• Do not use on or near water. This is not a raft.
• Do not set up bed near stairs, doors, sharp edges or breakable objects. Provide adequate space between
bed and objects to avoid entrapment.
• Make sure the area is flat, smooth, free of sharp objects that could puncture the bed and keep away from
ledges.
• Keep pets away from the airbed. Pets may puncture the surface of the bed.
• Avoid sleeping on the edge of the airbed. Edges produce less support than the middle
of the bed.
• Do not operate air pump for more than 10 minutes at a time. Let pump cool at least 10
minutes between uses.
• Unplug electrical power cord when not in use. To disconnect, turn all controls to the off position, then remove
plug from outlet.
• Never operate the furnishing with the air openings blocked. Keep the air openings free of lint, hair, and
the like. Never drop or insert object into any opening.
• Never operate this furnishing if it has a damaged cord or plug, if it is not working properly, if it has been
dropped or damaged, or dropped into water. Return the furnishing to a service center for examination and/or
repair.
• If the AC supply cord is damaged, it must be replaced by the manufacturer or its service agent in order to
avoid a hazard.
• Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not
route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped
over. Keep the cord away from heated surfaces.
FOLLOW THESE RULES AND ALL INSTRUCTIONS TO AVOID SUFFOCATION,
PROPERTY DAMAGE, ELECTRIC SHOCK, BURNS OR OTHER INJURY.
WARNING
•
To reduce the risk of electric shock or injury, use indoors only, do not expose to rain. Store indoors.
CAUTION
5
4
3
2
1
6
7
9
8
10
FIG (1)
FIG (3)
•
To reduce the risk of electric shock: Always unplug this furnishing from the electrical outlet before cleaning.
DANGER
SERVICING OF A DOUBLE-INSULATED PRODUCT:
In a double-insulated product, two systems of insulation are provided instead of grounding. No grounding
means is provided on a double-insulated product, nor should a means for grounding be added to the
product. Servicing of a double-insulated product requires extreme care and knowledge of the system,
and should be done only by qualified service personnel. Replacement parts for a double-insulated
product must be identical to those parts in the product.
A double-insulated product is marked with the words "DOUBLE INSULATION" or "DOUBLE INSULAT-
ED" and with the symbol .
Part Descriptions:
1. AIRBED
2. "2 IN 1" VALVE
3. HANDLE
4. STORAGE POCKET
5. FOAM VACUUM VALVE
6. INFLATION SWITCH
7. ADJUSTING SWITCH
8. REMOTE CONTROL
9. AC LINE CORD
10. AIR PASSAGE
PARTS REFERENCE
INSTRUCTIONS
General
• This appliance has a polarized plug (one blade is wider than the other).
This plug will fit in a
polarized outlet only one way.
If the plug does not fit fully in the outlet, reverse the plug.
If it still
does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
• No air pump maintenance is required.
•
For cleaning use only mild soapy solution. Do not use any chemicals.
•
In case of repairs, use only common PVC repair glue and patches.
To Next Page
Need help?
General
