(260PO) MODEL ECO7110&8110 SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 05/15/2015
260
PO
SAVE THESE INSTRUCTIONS
English
Page 8
SETUP INSTRUCTIONS (continued)
1. Go directly to step 2 if your pool is empty. If your above-ground-pool is filled with water,
unscrew the strainer grids from the strainer connectors and insert the black hat-like plugs
into the connectors, before installing the saltwater pool system.
2. Connect the adaptor A (1) to the electrolytic cell (3) outlet as shown in Drawing #1. Tighten
securely.
3. Disconnect the water return hose from the filter pump connection and connect it to the
adaptor A (1) on the Saltwater System with a hose clamp. (see Drawing #1)
4. Connect adaptor B (8) to the connector hose (7). Tighten securely. (see Drawing #1)
5. Connect adaptor B (8) to filter pump outlet (lower connection). Tighten securely.
6. Remove the black hat-like plugs that prevent water from flowing out of the pool. Now, return
the strainer grids to the strainer connectors.
7
8
1
3
7
8
Filter
Pump