Intex krystal clear 636T User Manual

(108) MODEL 636T FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/06/2016
108A
SAVE THESE INSTRUCTIONS
English
Page 12
CLEANING OR REPLACING FILTER CARTRIDGES
It is recommended that the filter cartridge be replaced at least every 2
weeks. Regularly monitor the filter clogging level.
1
. Make sure the filter pump is turned off, then disconnect the power cord from the electrical
outlet.
2
. Turn both plunger valve handles fully clockwise until they stop. This closes the valve, prevents
the water from flowing out of the pool.
3
. Gently turn the top air release valve once or twice in a counter-clockwise direction. The
housing cover can now be easily removed.
4
. In a counter-clockwise direction remove the filter housing collar
(1).
Place it in a safe location.
5
. Remove the housing cover
(4).
6
. Now remove the used filter cartridge.
7
. Examine the inside of the filter housing.
8
. If dirt or sediment is located on the bottom of the housing then:
A
. In a counter-clockwise motion gently unscrew and remove the sediment valve
(2)
located
at the bottom of the housing. Place it in a safe place.
B
. With a bucket of water or a garden hose pour water into the housing flushing out the
sediment.
C
. Screw back the sediment valve
(2)
in a gentle clockwise motion. Do not over-tighten.
9
. Place a new cartridge filter in the housing. Only use the original Intex cartridge for
replacement. See “Parts Reference” section for detail.
10
. Return the housing cover
(4)
to its position and in a clockwise direction rescrew the housing
collar
(1)
onto the filter housing.
11.
Turn both plunger valve handles fully counter-clockwise until they stop. This opens the valve,
allowing water to flow into the filter pump.
12
. When the trapped air has escaped through the air release valve gently retighten the valve
(2)
in a clockwise direction.
13
. Reconnect the power cord.
14
. Turn on the pump.
15.
Check the inlet and outlet openings regularly to ensure they are not obstructed thus
preventing a good filtration.
16.
The disposal of any used filter media should be in accordance with applicable local regulation
and legislation.

Intex krystal clear 636T Specifications

General

Brand	Intex
Model	krystal clear 636T
Category	Water Pump
Language	English