Intex Krystal Clear C1500

Questions and Answers:

W
williamskaylaSep 9, 2025
Why is there a small leak from the air jet valve of my Intex Krystal Clear C1500 Water Pump when it's on?
- T
  Tammy GarciaSep 9, 2025
  A small leak from the air jet valve when the pump is on may be due to accessories attached to the water circulation line. Remove all accessories, such as solar mats, auto pool cleaners, and LED lights, from the water circulation line. Place the air jet valve cap over the air jet valve. Do not cover the air jet valve with the valve cap under normal situations or when the pump is operating.
M
Monique RiveraSep 12, 2025
How to stop my Intex Water Pump hose from leaking?
- D
  dashleySep 12, 2025
  To stop an Intex Water Pump hose from leaking, first, tighten or reinstall the hose nut to ensure it is well-fitted. Check if the hose o-ring dislodged during connection and put it back into the groove. If the hose is broken, replace it with a new one.
B
Benjamin CrawfordSep 12, 2025
How to resolve an Intex Krystal Clear C1500 top cover leaking?
- D
  daniel96Sep 13, 2025
  If the top cover of your Intex Water Pump is leaking, first remove the cover and check for a missing O-ring. Also, ensure that the cover or air release valve are tight by manually tightening them.
J
Jessica GriffinSep 15, 2025
What causes a small leak from the air jet valve on my Intex Water Pump when it is on?
- M
  Monica ChandlerSep 15, 2025
  A small leak from the air jet valve on your Intex Water Pump when it's running can be due to accessories attached to the water circulation line. Remove all accessories like solar mats, auto pool cleaners, and LED lights. Then, place the air jet valve cap over the air jet valve. Remember not to cover the air jet valve with the cap under normal operation.
I
Isaac PattersonSep 17, 2025
How to fix a leaking Intex Krystal Clear C1500 inlet threaded air connector / air jet valve?
- A
  Austin FrancisSep 17, 2025
  To fix a leaking inlet threaded air connector or air jet valve on your Intex Water Pump, start by tightening or reinstalling the plunger valve to ensure it is well-fitted. Then, tighten the air jet valve, making sure it’s facing up. If the internal seal is blocked, turn the pump on for a few seconds, then off, and repeat this process three times. If the internal seal is dirty, remove the air jet valve, flush out the dirt with water, and replace the valve. If the air jet valve is broken, replace it with a new one.