Intex PureSpa SSP-10 - LED Code Chart; Error Code Troubleshooting

192
PO
S AVE THESE INSTRUCTIONS
(192PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 04/18/2013
English
Page 12
LED CODE CHART
E90 Nowaterow
• Ensuretheunitispluggedandswitchon.
• Ensuretheoutletcovergridiscleanandfree
from obstructions.
• Cleanorreplacethecartridge,seeMaintenance
and Storage section.
• Ensurethein/outletconnectionsonthespatub
andlterpumparenotblocked.
• Ifproblempersists,contactIntexService
Center.
E94 Water temperature too low
• Iftheambienttemperatureisbelow39°F(4°C),
we recommend not to use the spa.
• Press the temperature increase button to set
the desired water temperature.
• Ifproblempersists,contactIntexService
Center.
E95 Water temperature too high
• Press the temperature decrease button to
lower the water temperature.
• Whenthewaterhascooleddownto104°F
(40°C),presstheRESETbutton.
• Ifproblempersists,contactIntexService
Center.
E96
SystemError
• UnplugandplugtheGFCI/RCD.
• Ifproblempersists,contactIntexService
Center.
END
After72hoursofoperation,
the pump will hibernate and
the rapid heating and water
ltrationfunctionsaredisabled.
• Pressthewaterlterbuttontore-activethe
lterpump.
LED Reading CAUSE SOLUTION