Intex PureSpa SSP-10 - Page 14

192
PO
S AVE THESE INSTRUCTIONS
(192PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 04/18/2013
English
Spa Tub Drainage
1. Turnoffallthebuttons(heater,lterandbubble)onthecontrolpanelunit.
2. Connectthedrainvalveadaptortoagardenhoseandpointtheotherend 
of the garden hose to a suitable draining area (see drawing 14).
3. Removethedrainvalvecapfromoutsideofthespatubandattachthe
 drainvalveadaptortothedrainvalve(see drawing 14).
4. Frominsideofthespatub,openthedrainvalvecap,waterwillstart
 owingoutfromthegardenhose.
5. When the water stops draining, disconnect the spa control unit from
 thespatubwall.Liftthespatubwallfromthesideoppositethedrain,
leading any remaining water to the drain and emptying the spa completely
(see drawing 15).
6. Raiseupthespacontrolunitandopenthecapunderneaththelter
pump unit, drain out the water (see drawing 16). Do not tighten the cap
now.
7. Attachedtheinationhose(7)totheairblowerinationoutletontop
of the control panel section.
8. Pressthebutton,aimtheinationhoseattheinlet/outletsonthespa
tub and spa control unit to dry out any water in the piping system.
(see drawings 17 & 18).
9. When the water stops draining, raise up the spa control unit again and
 tightenthecapunderneaththelterpumpunitback(see drawing 19).
10. Useacleantoweltowipeupanyremainingwaterandmoistureonthe
spa tub and spa control unit.
11. Ensurethespatubandspacontolunitarethoroughlydried.
NOTE: The enclosed plugs (15) canbeusedtocoverthewaterinletand 
 outletconnectorsfromtheinsideofthespatubtopreventwaterfrom
 owingout.
Spa Tub Cleaning
Ifdirtisvisibleinthewaterorwaterbecomescloudyandproperwater
chemistry does not clear it up, change the water and clean the spa tub.
See“SpaTubDrainage”sectiononhowtodrainthespa.
Whileempty,removethecartridgehousingfrominsideofthespatubwall,
cleanand/orreplacetheltercartridge.Useaspongeandmildsoapsolution
to wipe away any soil or stains on the inside of the spa wall. Rinse thoroughly
beforerellingwithcleanwater.
IMPORTANT: Donotusesteelwool,hardbrushesorabrasivecleaners.
Spa Tub Air Valve Fastening
Checkthespatubairvalveforleakageandtightnessbeforeuse.Ifairisleaking
fromtheairvalve,usetheprovidedwrench(22) totightentheairvalveasfollow:
1. Makesurethespatubisdeated,opentheairvalvecapandinsertthe 
wrench (22)intotheairvalvebody (see drawing 20).
2. Withonehand,holdthebacksideoftheairvalvebasefromtheinsideof 
the spa tub wall and turn the wrench (22) clockwise.
IMPORTANT:Donotovertightentheairvalve.Neveradjusttheair
 valvebasewhenthespaisinuseorlledwithwater.
Spa Cover
Inspectthespacoverregularlyforleaks,prematurewearandtear,damage,
orsignsofdeterioration.Neveruseawornordamagedcover:itwillnot
providethelevelofprotectionrequiredtopreventunsupervisedaccesstothe
spa by a child.
MAINTENANCE
Page 14
14
17
16
19
18
˚
C
˚
F
RESE T
104
F
o
1
2
3
20
11
22
7
7
15