133
SAVE THESE INSTRUCTIONS
Page 20
(133) MODEL CS8111 SALTWATER SYSTEM & FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 11/17/2011
English
OOPPEERRAATTIINNGG IINNSSTTRRUUCCTTIIOONNSS
FILTER PUMP OPERATION
1. Make sure the unit is switched off. The switch is located on the control station.
2. Connect the power cord to a GFCI protected electrical outlet.
3. Grasp a plunger valve handle. Turn the handle counter-clockwise, pull up until it
stops, and then turn it clockwise until the metal protruding notch anchor is in the
"0/1" position. Repeat for the second plunger valve. This opens the valves,
allowing water to flow into the unit.
4. With water flowing into unit, the water pressure will allow the air trapped inside
to escape from the air release valves (1 & 7). When all the air has escaped
water will flow out of the valves (1 & 7). When this occurs gently finger tighten
the valves in a clockwise direction.
5. Turn on the switch. The filter pump is now filtering the water.
6. The green "Pump" light on the control panel will light up, that indicates the filter
pump is running.
To prevent air lock, open the lower plunger valve (connected inlet hose)
first and then the upper plunger valve (connected outlet hose). Open air
release valves, lift and lower the inlet hose until water starts to flow out of
the air release valves, close air release valves.
IMPORTANT
Risk of electric shock. Connect this product only to a grounding type
receptacle protected by a ground-fault circuit interrupter (GFCI). Contact a
qualified electrician if you cannot verify that the receptacle is protected by
a GFCI.
WARNING
7
1
To Next Page
Loading...
Need help?
General
