EasyManuals Logo

Intex SimpleSpa SB-B20 User Manual

Intex SimpleSpa SB-B20
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
348
A
S AVE THESE INSTRUCTIONS
(348IO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 10/09/2019
English
Page 10
SET UP (continued)
Setup the spa with at least 2 persons.
1.
Move the entire package to the selected site. Do not drag the spa tub across the ground as this can
cause damage and leakage.
Open the carton carefully as this carton can be used to store the spa during long term storage or when
not in use.
2.
Lay out all the parts on the ground and make sure all the parts are accounted for. For missing or
damaged parts contact the appropriate Intex Service Center listed in the separate “Authorized service
Centers” sheet.
Spa Control Panel Adjustment
1.
Pushtheleverdowntotiltupthecontrolpanelandipupthepanelcover
(see drawing 1.1)
.
2.
To stow the control panel back push the button located on the back inward while pushing the control
panel down
(see drawing 1.2)
.
Humidity is a natural side effect of indoor spa installation. The room shall be properly ventilated to allow
moisture to escape. Install a ventilating system to prevent excess condensation, moisture in the room.
Additional requirements for outdoor installation
Spa owners may need to comply with local or states laws relating to childproof fencing, safety barriers,
lighting,andothersafetyrequirements.Contactyourlocalbuildingcodeenforcementofceforfurther
details.
• Makesurethesurfaceislevel,at,smoothandstrongenoughtosupportthefullweightofthelledspa.
Do not setup the spa on grass or dirt, as this increases the amount of debris entering the spa, and
damagethespaoor.
Do not expose the spa to direct sunlight for extended period of time. Provide protection from the
sun such as sunshade, tent, awning or gazebo.
It is possible to install and leave the spa outside at a temperature not lower than 4°C (39°F) provided the
water temperature inside the spa is higher than 4°C (39°F) and the water inside the circulation system,
pump,pipearenotfrozen.Puta“tempbarriermat”betweenthespaoorandthegroundtopreventheat
loss from the bottom of the spa and to provide better heat retention. Do not use the spa if the ambient or
water temperature is 4°C (39°F) or lower.
1.1
1.2
1
2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intex SimpleSpa SB-B20 and is the answer not in the manual?

Intex SimpleSpa SB-B20 Specifications

General IconGeneral
BrandIntex
ModelSimpleSpa SB-B20
CategoryHot Tub
LanguageEnglish

Related product manuals