Intex SimpleSpa SB-B20 - Page 13

348
A
S AVE THESE INSTRUCTIONS
(348IO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 10/09/2019
English
Page 13
SET UP (continued)
Thespatubination/deationvalveincorporatesan“airpressurerelease”functionthatautomatically
releases excess air when the spa tub internal pressure is between 0.363 - 0.508 psi (0.025 - 0.035 bar).
Air pressure release valve.
Colder temperatures at night
cause the spa to seem less
inated.
Air expands in the midday
heat and correct air
pressure is restored.
Air expands in the midday heat.
Air pressure release valve kicks
in and releases excess air.
Inationofspainthemorning.
IMPORTANT
Inate the Spa Cover Air Bladder
1.
Opentheinationvalveandinserttheinationhose
(7)
into the
valve; press toinateuntilitisrmtothetouchbutnothard
(see drawing 7)
.
2.
Disconnecttheinationhose
(7)
fromtheairblowerinationoutlet
and the valve.
3.
Replacethecontrolbaseinationlatch back; close and recess the
inationvalve.
NOTE:
If there is a need to add some air to the spa tub wall or spa
coverairbladderaftertheyhavebeensetup,refertoabove“Inate
theSpaTubWall”and“InatetheSpaCoverAirBladder”sections.
The cover air bladder is preinstalled inside the spa cover. If it needs to
bereinstalled,placetheuninatedairbladderinsidethespacoverlipbeforeinatingthebladder.
Deation
For Spa Tub Wall:
1.
Unscrew the cap to reveal the stem, push the stem in and turn
90 degree right to secure it in the down position
(see drawing 8)
.
2.
Oncethedeationiscompleted,pushthesteminandturn90
degreelefttoreturnittotheinationposition.
3.
Replace the cap back.
NOTE:
Todeatethespatubforstorage,see“STORAGE”section.
For Cover Air Bladder:
1.
 Pullvalvecapoutandsqueezethevalveatitsbaseuntildeated.
2.
Close and recess the valve back.
8
7
7