Intex SimpleSpa SB-B20 User Manual

348
A
S AVE THESE INSTRUCTIONS
(348IO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 10/09/2019
English
Page 12
SET UP (continued)
4.
Press the button to turn on the control panel. Press the
 buttontoinatethespatubwallfor8to10minutesuntilitisrm
to the touch but not hard
(see drawings 4.1 & 4.2)
. During the
inationprocesscheckthatthespatubexternallining
(31)
top
surface is fully extended and covering the spa tub
(16)
top air
chambersurface,makeadjustmentasneeded.Afterinationafew
wrinkles may be present on the spa tub external lining, this is normal.
IMPORTANT:
Donotoverinateorusehighpressureair
 compressortoinate.
5.
Press the button again to turn it off.
6.
 Afterination,ifthehorizontaltopseamoftheexternallining
(31)
is not aligned with the spa tub
(16)
horizontal top seam
(see drawing 5)
, let some air out of the the spa tub, then adjust the external lining
andre-inatethespatub.
7.
Replace the air valve cap back.
The cap is designed to be screwed on and off. Never exert force
asthiscouldcausethecompleteinternalinationsystemofthe
valve to come loose. See “Spa Tub Air Valve Fastening” for valve
maintenance.
NOTE:
If there is a need to replace the spa tub air pressure release
valve core
(23)
due to wear and tear, use the included wrench
(22)
to
unscrew the core from the valve base. Insert the replacement core and
tighten with the wrench. Make sure the core is securely tightened
(see
drawing 6)
.
4.2
IMPORTANT:
To prevent damage to the air blower motor never
blocktheairbloweroutletopeningduringination.
4.1
6
22
23
5

Intex SimpleSpa SB-B20 Specifications

General

Brand	Intex
Model	SimpleSpa SB-B20
Category	Hot Tub
Language	English