Why is my Intex ZX300 Swimming Pool Vacuum AUTO Cleaner movement very slow?
If the movement of your Intex Swimming Pool Vacuum AUTO Cleaner is very slow, try the following: Check and clean the debris net and micro-screen. Also, clean or replace the filter pump cartridge. If you are using a sand filter, ensure the sand media is clean by backwashing it.
How to fix Intex Swimming Pool Vacuum AUTO Cleaner that doesn’t move?
If your Intex Swimming Pool Vacuum AUTO Cleaner isn’t moving, ensure that the filter pump is operating and within the specified pump flow rate [1600 - 3500 gallons/hour (6056 - 13248 liters/hour)]. Lift the auto cleaner out of the water and check if water is flowing out from the “water outlet” located on the top of the device. Also, tighten the hose collar nut securely and connect the hose to the water return connector. Remove the cleaner base, check if the gear box is stuck, turn the wheels by hand and see if the wheels rotate, if not, replace a new unit.
What to do if Intex Swimming Pool Vacuum cleaner can not climb the pool wall?
If your Intex Swimming Pool Vacuum cleaner can't climb the pool wall, make sure the pool water chemistry is balanced. If the pool water is green, brown, or black, adjust the chlorine and pH levels. Also, check if the pump flow rate is within the specified range. If the pump flow rate is less than 1600 gal/h (6056 liters/h), consider changing the pump to one with a higher flow rate.
What to do if Intex Swimming Pool Vacuum can not pick up the Leaves on pool floor?
If your Intex Swimming Pool Vacuum can't pick up leaves on the pool floor, remove the brushes from the underside and put the Auto Cleaner back into the pool. Also, clean the debris net and micro-screen from the Auto Cleaner after operating for 2-3 hours continuously.
Why does Intex Swimming Pool Vacuum take longer time to reverse direction?
This is normal, as the auto cleaner reversing time is dictated by the size of the filter pump flow rate.
Details critical safety warnings for product use, emphasizing potential risks and proper handling procedures.
Provides essential preparation guidelines and requirements before installing and operating the automatic pool cleaner.
General| Type | Automatic Pool Cleaner |
|---|---|
| Waterproof Level | IPX8 |
| Pool Type | Above Ground |
| Maximum Flow Rate | 3, 500 GPH |
| Cleaning Coverage | Floor and Walls |
| Charging Time | Not Applicable |
| Run Time | Continuous with Pump Operation |
| Included Components | instruction manual |
To Next Page
