Why is my Intex Auto Cleaner moving so slow?
If your Intex Swimming Pool Vacuum's movement is very slow, try these steps: * Check and clean the debris net. * Clean or replace the filter pump cartridge. * If you're using a sand filter, backwash it to ensure the sand media is clean. Consult your sand filter owner’s manual for instructions. * If the speed is still unsatisfactory, consider using a filter pump with a higher flow rate.
What to do if Intex Auto Cleaner doesn't move?
If your Intex Swimming Pool Vacuum isn't moving, here's what you can do: * First, make sure your filter pump is working. Take the cleaner out of the water and see if water comes out of either end. * Next, check that each hose section is tightly connected and that the hose is properly connected to the water return connector. * Also, lift the cleaner from any wrinkled areas and ensure the pool floor is as smooth as possible. * If the problem persists, contact the Intex Service Center.
Why does my Intex Auto Cleaner lift off the pool floor?
If your Intex Swimming Pool Vacuum lifts off the pool floor: * Release any trapped air by following the setup instructions. * Ensure your pool water chemistry is balanced, if the water is green, brown, or black, adjust the chlorine and pH levels. Refer to your pool owner’s manual for guidance. * Verify that the pump flow rate is within the specified range. If it exceeds 3500 gal/h, switch to a pump with a lower flow rate.
Instructions for cleaning the debris net and cleaner base.
Guidance on storing the auto cleaner when not in use.
General| Compatibility | Above Ground Pools |
|---|---|
| Pool Type | Above-ground |
| Cleaning Coverage | Floor |
| Suitable For | Above-ground pools |
| Warranty | 1-year limited warranty |
To Next Page
