- 44 -
If other messages are displayed
Troubleshooting
1
2
IndexMaintenance
Message displayed on the
liquid crystal panel
Error
code
<ATTENTION>
lamp
Causes and Troubleshooting
Reference
pages
Spot Color Duct has not been
installed
Please install the Spot Color Duct
Please see HELP for details
676 Blinking
Spot Color Duct has not been installed.
Please install the Spot Color duct.
(SP1360S only)
-
Toner Duct has not been installed
Please install the Toner Duct
Please see HELP for details
676 Blinking Toner Duct has not been installed.
Please install the Toner duct.
(SP1360W only)
-
Check Image Drum and Toner
Cartridge
[COLOR]
Please see HELP for details
5440
*1
5441
5442
5443
5444
*2
Blinking The toner cartridge shown in the
message is not set correctly.
Press the [HELP] button, and solve
according to the guidance shown on
the Help screen.
*1: 5440 will appear only for
SP1360W.
*2: 5444 will appear only for
SP1360S.
-
Check Toner Duct
Please see HELP for details
5440 Blinking The toner duct is not properly
installed.
Reset the toner duct.
Press the [HELP] button, and solve
according to the guidance shown on
the Help screen.
(SP1360W only)
-
Check Spot Color Duct
Please see HELP for details
5444
5445
Blinking The spot color duct is not properly
installed.
Reset the spot color duct.
Press the [HELP] button, and solve
according to the guidance shown on
the Help screen. (SP1360S only)
-
Toner Not Installed
[COLOR]
Please see HELP for details
6100
6101
6102
6103
6104
6105
Blinking The toner cartridge shown in the
message has not been installed.
Press the [HELP] button, and solve
according to the guidance shown on
the Help screen.
-
The toner replacement cover is
open
Please see HELP for details
586 Blinking The toner replacement cover is
open.
Check that the toner cartridge is
pushed in rmly as far as it can go,
and close the toner cover.
-
Install Paper Cassette
[TRAY]
Please see HELP for details
430
431
432
433
434
Blinking There is no paper cassette in the
tray shown in the message.
Set the paper cassette in the tray
shown in the message.
When the paper cassette is already
there in the tray, pull the cassette
out and set it correctly.
-
Install Exit Unit
Please see HELP for details
333 Blinking The exit unit is missing.
Please install the exit unit.
-
Check Waste Toner Box
Please see HELP for details
331 Blinking The waste toner box is not set
correctly.
Reset the waste toner box.
-
Reset Waste Toner Box
Waste Toner Transfer Error
Please see HELP for details
359 Blinking A waste toner transfer error has
occurred.
Press the [HELP] button, and solve
according to the guidance shown on
the Help screen.
-
To Next Page
Loading...