Intoprint SP1360S - Moving and Shipping the Device

IndexTroubleshooting
1
2
Maintenance
- 100 -
Moving and shipping the device
z
Moving and shipping the device
This section describes about transporting or moving the device.
Moving the device
CAUTION
There is a risk of injury.
The printer weighs approx. 98 kg* for SP1360
models, and approx. 111 Kg* for SP1360W/
SP1360S model. Therefore, make sure to use at
least 4 people when lifting.
*: Includes consumables such as the image drum and toner
cartridge, etc.
1
Press and hold the power switch for
approx. 1s. Check that the operation
panel is completely switched o after
that, and switch o the main power
supply by pulling the main power supply
switch to the OFF (O) side.
2
Remove all cables.
z
Power supply cable and earthing cord
z
LAN cable/USB cable
3
Remove paper from the tray.
4
Life the device with 4 people, and move
it to the destination.
Shipping the device
CAUTION
There is a risk of injury.
The printer weighs approx. 98 kg* for SP1360
models, and approx. 111 Kg* for SP1360W/
SP1360S model. Therefore, make sure to use at
least 4 people when lifting.
*: Includes consumables such as the image drum and toner
cartridge, etc.
Note
z
Because image drums (green parts) can easily get
damaged, handle with adequate care.
z
Do not expose the image drum to direct sunlight or strong
light (About 1,500 lux or more). Do not keep it for more
than 5 minutes even under room lighting.
1
Press and hold the power switch for
approx. 1s. Check that the operation
panel is completely switched o after
that, and switch o the main power
supply by pulling the main power supply
switch to the OFF (O) side.
2
Remove all cables.
z
Power supply cable and earthing cord
z
LAN cable/USB cable
3
Remove paper from the tray.
4
Remove all toner cartridges.