Invacare 3750 - Page 16

SECTION 2—PARTS AND INSTALLATION
Recessed Side Entry Bath Tubs 16 Part No 1150695
13. Model3750Only‐Performthefollowingstepstoinstalltheshowerwand:
A. Determinethemountinglocationfortheshowerwandandmarkthisonthewall.
NOTE:Ashowerwand,showerhose,supplyelbows,hangerpegsandaflexiblesupplyline
havebeensuppliedwiththetub.
B. Plumbthesupplylinetothedivertedoutputportofthemixvalve.
C. Routethesupplylinebehindthebackwalltothelocationofyourchoice.
D. Drillaholeinthewalltoaccommodatetheplasticcompressionfittingontheback
andthechromeelbowonthefront.
NOTE:Itisadvisableto“hardplumb”theshowersupplyelbowusingstandardcopperpipe
andbrassfittingsstrappedtothestudsbehindthedrywallorpaneling.
FIGURE 2.3 Shower Wand Plumbing (Model 3750 Only)
14. Installaserviceaccesspanel(minimum16x14‐inches)onthewall(thebackwallor
rightwall)toallowthepumpandcontrolstobeserviced.
FIGURE 2.4 Installing the Tub
Shower Supply
Line
A
LETTER DESCRIPTION LENGTH IN INCHES
A Door Swing Clearance 40 minimum (60 for wheelchair or lift access)
B Length of Tub 59.5
CTub Width 31.5
D Tub Height 41.5
E Seat Height 19
Front View
Top View
B
C
D
E
B
Model 3800 -
Hot and Cold
Water Stubs
On This End
Model 3750 - Hot and Cold Water Stubs
On This End
Motor Pump Hookup
On This End