Switching on/o
1. Switching on:
a. Press and hold the button at the side of the switch box.
b. Pull and hold the switch bar towards the handle.
Once the motor is running, you can release the button (1)
Switching o:
Release the switch bar.
NOTE: The cutting device will continue to rotate for a short
period after the product has been switched o.
WARNING! To ensure safe operation the height adjustment
of the handle is limited by the toothed area. To not attempt
changing the height outside this range!
75 mm
25 mm
1
2
I
O
64
To Next Page
Loading...
