EasyManua.ls Logo

INVENTOR IW14BL - Maintenance & Cleaning

INVENTOR IW14BL
116 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
EN
Prior to cleaning the appliance, un-plug
from the wall power socket, and remove
all shelves.
• Clean the appliance with a moist soft
cloth. Use only neutral detergents.
• Clean the unit’s interior with a weak
bicarbonate soda solution and rinse
with warm water applying a damp
sponge or cloth.
• Use a damp cloth to clean the exterior,
keep in mind the door must be shut to
avoid getting any polish on the magnetic
door seal or the interior of the unit.
• Make sure not to let any water spill on
the control elements of the door.
• Be certain that there is no water spilling on the control elements of the door
• While cleaning, you may lightly rinse the interior with water and dry
• Allow the appliance to dry for
approximately 1 to 2 hours.
• Set thermostat to NORMAL position.
Plug into a power source. The
appliance will chill continuously until
set temperature has been reached.
• Be sure to regularly clean the drain
hole to ensure proper drainage.
Do not use abrasive products, abrasive cleaning pads,
solvents or metal objects. Do not use water spray and
steam to clean the appliance.
Do not use extreme moist cleaning pads. Any moisture
around the electric components, should be avoided.
• The use of a steam cleaner is prohibited, as this may
be very dangerous.
9. MAINTENANCE & CLEANING
Clean the
interior of
the appliance
ONCE A
MONTH

Table of Contents