User’s Manual of Remote Controller
7
In winter, absence function can keep the indoor ambient temperature above 0℃ to
avoid freezing.
Note: Absence function is only available in heating mode and it will be exited when
switching mode or setting sleep function.
1.5 Replacing batteries in remote controller and notes
(1).
Lift the cover along the direction of arrow (as shown in Fig 1①).
(2).
Take out the original batteries (as shown in Fig 1②).
(3).
Place two 7# (AAA 1.5V) dry batteries, and make sure the position of “+” polar
and “-” polar is correct (as shown in Fig 2③).
(4).
Reinstall the cover (as shown in Fig 2④).
Fig.1 Fig.2
Notes:
①
.
The remote controller should be placed 1m away from the TV set or stereo
sound sets.
②
.
The operation of remote controller should be performed within its receiving
range.
③
.
If you need to control the main unit, please point the remote controller at the
signal receiving window of the main unit to improve the receiving sensibility of
main unit.
④
.
When the remote controller is sending signal, “ ” icon will be blinking for 1
second. When the main unit receives valid remote control signal, it will give
out a sound.
⑤
.
If the remote controller does not operate normally, please take the batteries
out and reinsert them after 30 seconds. If it still can't operate properly, replace
the batteries.
⑥
.
When replacing the batteries, do not use old or different types of batteries,
otherwise, it may cause malfunction.
⑦
.
When you won’t use the remote controller for a long time, please take out the
batteries.
To Next Page
Loading...
Need help?
General
