2
Use the remote controlle r within a distance of 8
meters from the appliance, pointing i t towards the
receiver. Reception is confirmed by a beep.
L o c a tio n o f th e r e mo t e co n t r ol le r.
C A UTIONS
The air conditioner will not operate if curtains, doors or other materials
block the signals from the remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose
the remote controller to di rect sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct
sunlight, the air conditioner may not function properly. Use curtains to
prevent the sunlight from falling on the receiver.
If other electrical appliances react to th
e remote controller. either move
these appliances or consult your local dealer.
The remote c ontroller is powed by two dry
batteries(R03/LR03X2) housed in the rear
part and protected by a cover.
(1) Remove the cover by pressing and sliding off.
(2) Remove the old batteries and i nsert the new
batteries,placing the(+) a nd (-) ends correctly.
(3) Reattach the cover by sliding it back into
position.
When the b atteries are removed, the
remote controller erases all programming.
After inserting new batterie
s, the remote
controller must be reprogrammed.
NOTE:
R eplacing ba t t e ries
H a n d li n g t h e r e m o t e c ont roller
To Next Page
Loading...
Need help?
General
