INVENTOR MGHP-12 Owner's Manual

9
T im e r ope ra tion
press the TIMER ON button can set the auto-on
time of the unit. And press the TIMER OFF button
can set the auto-off time of the unit.
1. Pres s the TIMER ON button. The remote
controller shows TIMER ON, the last Auto-on
setting time and the signal "h" will be sho wn on
the LCD display area. Now it is ready to reset the
Auto-on time to START the operation.
2. Pus h the TIMER ON button again to set desired
Auto-on time. Each time you pre ss the button,
the time increases in 30 minutes increments, up
to 10 h
ours, then at 1 hour increments up to 24
hours.
3. After setting the TIMER ON ,there will be a one-
half second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signal "h" will disappear and the set temperature
will re-appear on the LCD display window.
To set the Auto-on time.
To set the Auto-off time.
1. Pres s the TIMER OFF button. The remote
controller shows TIMER OFF, the last Auto-off
setting time and the signal "h"
will be shown on
the LCD display area. Now it is ready to
reset the Auto-off time to START the operation.
2. Pus h the TIMER OFF button again to set desired
Auto-off time. Each time y ou press the button,
the time increases in 30 minutes increments, up
to 10 hours, then at 1 hour increments up to 24
hours.
3. After setting the TIMER OFF ,there will be a one-
half second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signa
l "h" will disa ppear and the set temperature
will re-appear on the LCD display window.
1
2
TEMP
AUTO
COOL
DRY
HEAT
FAN
HIGH
MED
LOW
MODE
FAN SPEED
SWING TIMER ON
ECONOMY
ON/OFF
TIMER OFF
RESET LOCK
SET TEMPERATURE( C)
LED
DISPLAY
TIMER ON

INVENTOR MGHP-12 Specifications

General

Brand	INVENTOR
Model	MGHP-12
Category	Remote Control
Language	English