INVENTOR MGHP-12 Owner's Manual

5
Function buttons (continued)
TIMER OFF Button
LOCK Button
Model: RG51B1/(C)EU,
RG51B/(C)EU,
RG51B26/(C)EU,
RG51B30/(C)EU,
RG51B31/(C)EU.
RG51B/(C)EU models
have no SWING and FOLLOW ME
buttons ;RG51B1/(C)EU models
have no FOLLOW ME button;
RG51B30/(C)EU models have no
SWING ,FOLLOW ME buttons and
MED FAN feature,and SLEEP button
instead of ECONOMY button;
RG51B31/(C)EU models have on
FOLLOW ME button.
NOTE:
TEMP
AUTO
COOL
DRY
HEAT
FAN
HIGH
MED
LOW
MODE
FAN SPEED
SWING TIMER ON
ECONOMY
ON/OFF
TIMER OFF
RESET LOCK
SET TEMPERATURE( F)
LED
DISPLAY
NOTE: While the unit i s running under SL EEP mode,
it would be cancelled if ON/OFF, FAN SPEED, SLEEP
or MODE button is pressed.
10
Press this button to activate the Auto-off time
setting. Each press will inc rease the time setting
in 3 0 minutes increments, up to 10 hours, then at
1 hour increments up to 24 h ours. To cancel the
Auto-off time setting, just press the button until
the ti me setting is 0.0.
11
Press this recessed button to lock all current
settings, an d the remote controller will not acce
pt
any operation except that of the LOCK. Use the
LOCK mode when you want to prevent settings
from being changed accidentally. Press the LOCK
button again to cancel the LOCK function. A lock
symbol will appear on the remote c ontroller display
when the lo ck function is activated.
Press this button to clear the display on the
indoor unit, press it again to light the display .
LED Display Button
12
TEMP
AUTO
COOL
DRY
HEAT
FAN
HIGH
MED
LOW
MODE
FAN SPEED
SWING TIMER ON
SLEEP
ON/OFF
TIMER OFF
RESET LOCK
SET TEMPERATURE( F)
TEMP
SENSING
LED
DISPLAY
ION
13
Press this button to initiate F OLLOW ME function.
When the Follow Me function is activated, the
remote display is actual temperature at its location.
The re mote control will send this signal to the air
conditioner every 3 minutes interval until press
the Fo llow Me button again.
The Follow Me function is no t available un der
DRY and FAN mode.
Switch the operation mode or turn off the unit will
cancel the follow me function automatically.
FOLLOW ME/TEMP SENSING Button
Model: RG51B17/(C)EU
13
14
When push this button, the ion generator is
energized and will help to remove pollen and
impurities from the air.
14
ION Button
9
NOTE:
RG51B18/(C)E ,RG51B19/(C)E-M,
RG51B20/(C)E models have no this feature.
FOLLOW
ME

INVENTOR MGHP-12 Specifications

General

Brand	INVENTOR
Model	MGHP-12
Category	Remote Control
Language	English