Turning the Device ON or OFF
1. Sliding the screen release lock forward will
unlock the LCD screen and it will drop down
slightly. Pivot the screen downward until a
comfortable viewing angle is reached. The
internal friction hinge will hold the screen
in position while the system is in use.
2. Pressing the POWER button on the front
panel or the remote will turn the system on
or off alternately. When in use the internal
backlighting will illuminate the controls.
3. After the unit has been turned on and is
displaying a picture, adjust the viewing
angle, by pivoting the screen to optimize
the picture quality.
4. Remember to turn the unit off and pivot the
LCD to the locked position when not in use.
Channel Tuning Setup (If available)
In order to easily access all available TV
channels, it may be necessary to perform
channel auto-programming whenever the
vehicle’s geographic location has changed (i.e.
city to city, weak signal are, etc.)
1. Press the AUTO MEMORY button on the
remote control unit. You will see the TV
cycling through all its channels. The built-
in microprocessor will automatically note
each channel that is actively broadcasting
in your area.
2. (A) To tune only strong clear channels
with the channel UP/DOWN buttons,
press the SKIP/SEARCH buttons on the
remote control unit until “SKIP MODE ON”
is displayed on the bottom of the screen.
The TV will now tune only to strong active
channels when the UP or DOWN buttons
are used on the monitor or remote control.
3. (B) To tune weak or marginal channels
with the channel UP/DOWN buttons,
press the SKIP/SEARCH the screen. Tune
to the desired channel using the UP or
DOWN buttons or go directly to the
channel by using the 0-9 buttons on the
remote control.
Overhead Dome Lights
The lights integrated into the G9 & G10 are
controlled by push-button switches. Push the
switch once, the light turns on. push-again, the
light turns off. Do not leave the vehicle
unattended with the dome light switch in the
on position, as this could result in the battery
being discharged.
Remote Sensor
The G9 & G10 incorporate an infrared sensor
which receives signals from the remote control
to allow it to be controlled simply by pointing
the remote control at the remote sensor eye.
This does not provide control of auxiliary
equipment. The infrared sensor cannot relay
signals from any manufacturer's remote
control to its respective component connected
to the video 1 and 2 inputs, such as a DVD
player. In this case you must use the remote
control supplied with the DVD player.
DVD Basics
To get the most use out of each DVD, make
sure you read this section completely.
Regional Coding
Both the DVD player and disc are coded by
region. These regional codes must match in
order for the disc to play. If the codes don't
match, the disc won't play. This unit's code is
set to the region it is being shipped to. By
default other regional codes cannot be played
in this unit.
Type of Discs your DVD will play
DVD-Video: DVD contains video.
CD-DA: CDcontainsmusical orsound contentonly.
CD-Video: CD contains movie only.
CD-R/RW: A disc that contains audio files (for
example, a CD-R with downloaded MP3 files),
MPEG, or JPEG files.
General Operating Instructions
16 General Operating Instructions
To Next Page