Need help?Do you have a question about the INVT GD100-160G-4-PV and is the answer not in the manual?
General| Model | GD100-160G-4-PV |
|---|---|
| Category | DC Drives |
| Power | 160kW |
| Voltage Class | 380V |
| Output Current | 320A |
| Cooling Method | Air Cooling |
| Protection Level | IP20 |
| Communication Interface | RS485 |
| Input Voltage | 3-phase 380VAC ±15% |
| Control Mode | V/F control, vector control |
| Communication Protocol | Modbus RTU |
| Overload Capacity | 150% for 60s |
| Protection Features | Overcurrent, overvoltage, undervoltage, overload, overheating, phase loss, short circuit |
| Operating Temperature | -10°C to +50°C |
| Storage Temperature | -20°C to 65°C |
| Relative Humidity | 5% to 95% non-condensing |
| Altitude | Up to 1000m without derating |
Provides essential safety rules for VFD operation, wiring, and handling.
Provides general guidelines for VFD wiring connections.
Guides on how to navigate menus and modify VFD parameters using the keypad.
Guidance on how to access and configure VFD operating parameters.
Lists and explains common parameters relevant to solar pumping applications.
Settings for configuring motor characteristics and autotuning.
Parameters for defining the Voltage/Frequency curve for motor control.
Configuration for various protection functions like phase loss.
Advanced parameters specific to PV inverter operation and control.
Details on diagnosing and resolving inverter unit U phase protection faults.
Troubleshooting steps for ACC overvoltage faults.
Guidance on identifying and rectifying motor overload faults.
Solutions for faults related to rectifier overheating.
Steps to diagnose and fix current detection circuit faults.
Information on troubleshooting PV overcurrent faults.
Guidance for addressing weak light alarms in solar operation.
Troubleshooting steps for the full-water alarm condition.
Solar module configurations recommended for solar pumping VFD models.
To Next Page
