Need help?Do you have a question about the INVT GD100-2R2G-2-PV and is the answer not in the manual?
General| Rated Power | 2.2 kW |
|---|---|
| Phase | Single-phase |
| Output Power | 2.2 kW |
| Frequency Range | 0-400Hz |
| Communication Interface | RS485 |
| Storage Temperature | -20°C to +60°C |
| Control Mode | V/F control |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overheat, Short circuit |
| Cooling Method | Air cooling |
| Humidity | 5% to 95% (non-condensing) |
| Altitude | Below 1000 m |
| Operating Temperature | -10°C to +50°C |
Defines safety terms and explains warning symbols used in the manual.
General safety rules for VFD installation, operation, maintenance, and disposal.
Covers unpacking, nameplate, and type designation for VFD models.
Detailed technical and rated specifications for various VFD models.
Requirements for VFD installation environment and orientation.
Guides on connecting main and control circuit terminals.
Introduction to keypad buttons, LEDs, display states, and navigation.
Procedures for changing VFD function codes, settings, and passwords.
Steps for initial inspection, trial run, and parameter setup.
Details common and special function parameters for VFD operation.
Lists common faults, causes, and remedies for VFD issues.
Information on optional modules, cables, reactors, and filters.
Recommended solar module configurations and PV switching solutions.
Physical dimensions of VFD models and accessories.
To Next Page