Goodrive20 inverters Function Parameters
83
Function
code
Name Detailed instruction of parameters
Default
value
Modify
13: Even check（E,8,1）for ASCII
14: Odd check（O,8,1）for ASCII
15: No check（N,8,2）for ASCII
16: Even check（E,8,2）for ASCII
17: Odd check（O,8,2）for ASCII
P14.03
0~200ms
It means the interval time between the interval time when
the drive receive the data and sent it to the upper monitor. If
the answer delay is shorter than the system processing
time, then the answer delay time is the system processing
time, if the answer delay is longer than the system
processing time, then after the system deal with the data,
waits until achieving the answer delay time to send the data
to the upper monitor.
5
○
overtime fault
time
0.0(invalid),0.1~60.0s
When the function code is set as 0.0, the communication
overtime parameter is invalid.
When the function code is set as non-zero, if the interval
time between two communications exceeds the
communication overtime, the system will report “485
communication faults” (CE).
0.0s
○
Transmission
fault
processing
0:Alarm and stop freely
1:No alarm and continue to run
2:No alarm and stop according to the stop means(only
under the communication control)
3:No alarm and stop according to the stop means(under all
control modes)
0
○
processing
0x00~0x11
LED ones:
0: Write with response: the inverter will respond to all
reading and writing commands of the upper monitor.
1: Write without response: the inverter only responds to the
reading command other than the writing command of the
drive. The communication efficiency can be increased by
this method.
LED tens:(reserved)
0: Communication encrypting valid
1: Communication encrypting invalid
0x00
○
To Next Page
Loading...
Need help?
General