INVT GD350-045G/055P-45-AS-B - Page 103

Goodrive350 IP55 High-ingress Protection Series VFD Basic Operation Instructions
-94-
Set
value
Function
Description
43
HDO
HDO from the programmable card
44
RO1
RO1 from the programmable card
45
RO2
RO2 from the programmable card
46
RO3
RO3 from the programmable card
47
RO4
RO4 from the programmable card
48
EC PT100 detected OH pre-alarm
Pre-alarm of overheating (OH) detected by the
expansion card (EC) with PT100.
49
EC PT1000 detected OH pre-alarm
Pre-alarm of OH detected by the EC with
PT1000.
50
AI/AO detected OH pre-alarm
Pre-alarm of OH detected by AI/AO.
51
Stopped or running at zero speed
The VFD is in stopped state or running at zero
speed.
52
Disconnection detected in tension
control
Disconnection is detected when the
disconnection detection is enabled in tension
control.
53
Roll diameter setting reached
The set roll diameter is reached during running
in tension control.
54
Max. roll diameter reached
The max. roll diameter is reached during running
in tension control.
55
Min. roll diameter reached
The min. roll diameter is reached during running
in tension control.
56
Fire control mode enabled
The fire mode is turned on.
57–63
Reserved
/
Related parameter list:
Function
code
Name
Description
Default
value
P06.00
HDO output type
0: Open collector high-speed pulse output
1: Open collector output
0
P06.01
Y1 output selection
0: Invalid
1: In running
2: In forward running
3: In reverse running
4: In jogging
5: VFD fault
6: Frequency level detection FDT1
7: Frequency level detection FDT2
8: Frequency reached
9: Running in zero speed
10: Reach upper limit frequency
11: Reach lower limit frequency
12: Ready to run
13: In pre-exciting
14: Overload pre-alarm
15: Underload pre-alarm
0
P06.02
HDO output selection
0
P06.03
Relay RO1 output
selection
1
P06.04
Relay RO2 output
selection
5