INVT Goodrive100-PV

Goodrive100-PV Series Solar Pumping VFD Function parameters
22
6 Function parameters
“○”: means the set value of the parameter can be modified on stop and running state;
“◎”: means the set value of the parameter cannot be modified on the running state;
“●”: means the value of the parameter is the real detection value which cannot be modified;
Note: The VFD implements auto checking and restriction on the parameter modification
property. This prevents users from modifying parameters by misoperation.
6.1 Common function parameters for solar pumping control
Function
code
Name
Detailed illustration of parameters
Default
Modify
P00 Group Basic function group
P00.00
Speed control
mode
0: SVC 0
No need to install encoders. Suitable in
applications which need low frequency,
big torque for high accuracy of rotating
speed and torque control. Relative to
mode 1, it is more suitable for the
applications which need small power.
1: SVC 1
1 is suitable in high performance cases
with the advantage of high accuracy of
rotating speed and torque. It does not
need to install pulse encoder.
2: SVPWM control
2 is suitable in applications which do not
need high control accuracy, such as the
load of fan and pump, and suitable when
one VFD drives multiple motors.
Note: In vector control, the VFD must
autotune motor parameters first.
2
◎
P00.01
Run command
channel
Select the run command channel of the
VFD.
The control command of the VFD
1
○