INVT iMars BG30KTR

iMars grid-tied solar inverters Installation
28
(6) Ensure the inverter is installed properly and tighten the M6X16 bolts into the screw holes
on the left and right side of inverter(tightening torque is 4NЬm). As shown in Figure 4.13.
Figure4.13 Installation of M6X16 bolts
4.4 Electrical installation
This section proposes to describe detailed electrical installation and related safety instructions.
Figure 4.14 Block diagram of the grid-tied solar system
z Improper operation during the wiring process can cause fatal injury to operator
or unrecoverable damage to the inverter. Only
qualified personnel can perform
the wiring work.
z
All electrical installations must be in accordance with local and national electrical
codes.
z All cables must be firmly attached, undamaged, properly insulated and
adequately dimensioned.
z It is not allowed to close the AC and DC breakers before the inverter is
electrically connected.
N
ote
z Read and follow the instructions provided in this section while observing all
safety warnings.
z
Always note the rated voltage and current defined in this manual. Never exceed
the limits.