iMars grid-tied solar inverters Display panel
51
6.4.5 System Information
Press “ ” and “ ” in the main interface to select “System Information”, and then press “ENT” to
view the parameters which is shown in figure 6.8.
System Information
Part No .
Serial No .
Soft Ver
Cert . Area
Run Param
Figure 6.8 System information
The system information include “product model”, “serial No.”, “software version” and “certificate
version”.
System Ver
Version1 : V1.05
Version2 : V1.05
MCU Version : V1.05
Figure 6.9 System version
6.4.6 Faults
Press “ ” and “ ” in the main interface to review the fault history, and then press “ENT” to view
the sub-menu which is shown in figure 6.10.
Fault
1: A005 Grid under freq
2: A001 Input under Volt
3:
1
Figure 6.10 Fault information
There are 8 pieces of fault information in the record which is shown in figure 5.10; otherwise it will
display “No Fault!” Refer to section 6.4.2 for more detailed information.
6.4.7 Inverter control
Press “ ” and “ ” in the control interface, and then press “ENT” to view the sub-menu which is
shown in figure 6.11.
Control Menu
On/Off
Clear
Restart
Factory
Figure 6.11 Control interface
Refer to the table below for detailed information.
Table 6-5 Inverter control
To Next Page
Loading...
