Skip Mode
This feature allows you to switch between computers in order to monitor them manually. You can dwell on
a particular port for as long as you like – as opposed to auto-scanning, which automatically switches after
a xed interval. To invoke Skip mode, key in the following hotkey combination:
Invoke hotkey mode with the [Num Lock] + [-] or [Ctrl] + [F12] combination.1.
Key in [Arrow]2.
Where [Arrow] refers to one of the arrow keys. After you press an arrow, you automatically exit •
hotkey mode and enter Skip mode where you can switch ports as follows:
Skips to the rst accessible port. (See Scan/Skip Mode for information regarding
accessible ports.)
Skips to the next accessible port.
56
To Next Page
Loading...
