When in Auto Scan mode, you can pause the scanning in order to keep the focus on a particular •
computer either by pressing P or with a left click of the mouse. During the time that auto-scanning is
paused, the command line displays: Auto Scan: Paused.
Pausing when you want to keep the focus on a particular computer is more convenient than exiting Auto
Scan mode because when you resume scanning, you start from where you left off. If, on the other hand,
you exited and restarted, scanning would start over from the very rst computer on the installation.
To resume Auto Scanning, press any key or left-click. Scanning continues from where it left off.
When in Auto Scan mode, ordinary keyboard and mouse functions are suspended – only Auto Scan •
mode compliant keystrokes and mouse clicks can be input. You must exit Auto Scan mode in order to
regain normal control of the console.
To exit Auto Scan mode press [Esc] or [Spacebar]. Auto-scanning stops when you exit Auto Scan 3.
mode.
To Next Page
Loading...
Need help?
General
