ION 902 - Sparkling Water Installation

www.naturalchoicewater.com
sParkLing Water instaLLation
These instructions apply to Models 903 and 904 only.
CAuTION: CO
2
tanks should be handled by adults only; do not allow handling
or access by children.
CO
2
tanks are under extremely high pressure (2000 PSI; 138 bar).
Handle with extreme care and avoid tipping, tilting, or dropping. Never place on
an elevated surface. Always secure the tank in a fixed position.
Keep away from heat. Never place in direct sunlight, a car trunk, furnace room,
or other location where heat may rise.
Do not transport full tanks without a license. CO
2
tanks can be ordered and
shipped from authorized HAZMAT shippers.
For optimal carbonation, the water supply should be at least 60 PSI (4 bar)
and ideally 80 PSI (6 bar). You can install an optional booster pump if the
water supply does not meet the PSI requirement.
1. Connect the CO
2
regulator to the CO
2
tank and tighten with
the wrench provided with the CO
2
regulator.
2. Connect the green CO
2
tubing (included with the ION) between the
CO
2
regulator and the back of the ION.
16