www.naturalchoicewater.com
requirements
Electrical Requirements
■ 120 VAC electrical supply on 10 amp circuit (US customers).
■ Follow all building codes, using GFI outlets where required.
Plumbing Requirements
■ DO NOT connect copper tubing directly to ION. Copper tubing may
be required by building code or regulation. Contact Natural Choice
Technical Support for specific instructions and recommendations for
adaptor fittings.
■ ¼ inch T-fitting to fit the pipes under the sink.
Recommended Tools
■ Some plumbing tools and/or teflon tape may be required to make the
connection under the sink at the water supply.
■ In the event service is required on the ION, locate the Torx 20 wrench
under the Faucet Cover to remove panel screws.
NOTE: The pipe wrench and teflon tape may vary with the water supply
connection.
Torx 20 wrench
(included and located
under the faucet cover)
Adjustable crescent
wrench
Teflon tape
CO
2
wrench
(for Models 903 and
904 only, included
with the CO
2
regulator)
8
To Next Page
Loading...