11
Adjusting Your Audio Level (Optional)
1. Select your entire recording by selecting “Edit”, then “Select…”,
then click “All”. You can also use Ctrl+A on a PC or APPLE+A on
a Macintosh to quickly select all.
Figure 4: Select All
2. Select the “Effect” menu and choose the desired effect.
a. There are various types of effects which are described
further in the software’s help section as well as on the
web (See Figure 5).
b. Normalize should be used to have the correct volume on
the recording. (See Figure 6)
Please note:
It is a good idea to place the needle on the record, while
it is stopped, before you begin the recording and press
‘Play’ on the turntable after you begin recording. If you
place the needle down while the record is spinning and
after you have began recording, there might be audible
clicks and pops. These clicks on pops might not allow
the Normalize effect to bring the volume of the recording
to the level that it should be.
To Next Page
Loading...
Need help?
General
