Filter Replacement for Stainless Steel Housings
Because of a ‘tight’ fit, it may not be possible to remove filter
cartridges from ‘S’ model filter housings as easily as in
the standard plastic housings. Therefore it may sometimes be
necessary to connect a water supply to give a helping hand
by hydraulicing out the cartridge. The steps below detail the
simple the procedure.
Step 1.
After removing the filter housing from the machine
insert the orange hose adaptor to the bottom connection.
(on some machines ie; Quattro, X5 it is possible to
undertake this task without removing the filter housing).
Step 2.
Connect a water supply and open the
supply tap.
Step 3.
Water pressure will slowly push
the cartridge out of its housing.
Apply silicone grease to the lip
seal and around the inside of
opening to aid the insertion of
the replacement cartridge.
NB: Snap Rings and ‘O’ Rings must be replaced every twelve months.
To Next Page
Loading...