3
iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569-0200 | support@ioptron.com | www.iOptron.com
stainless steel lever into the Primary Altitude Locking
Screw and thread on the lever end screw. Then
loosen the Primary Locking Screw.
Use the Latitude Adjustment Knob to move the
mount to the desired latitude by aligning the scale to
the latitude Mark Line. Tighten both Primary Locking
Screw and Secondary Lever.
There are holes on the Latitude Adjustment Knob. An
Allen wrench may be inserted for increased
adjustment torque, if needed.
To use the mount near the equator, change the
latitude range settings to 0°~31°. To use the mount at
AA mode, change the range to 56°~90°. Please refer
to on-line instruction for detailed procedures.
5. Install telescope: HAE69 is equipped with a
Vixen/Losmandy-D dual dovetail saddle. It accepts a
Vixen or a Losmandy-D dovetail mounting bar.
6. Connect cables: Connect the Go2Nova
®
8409 Hand
Controller to the HBX port on the mount back. Plug in
a 12V DC power supply to the DC12V IN socket.
7. Set Zero Position: The Zero Position is the mount
GOTO reference. Without setting the mount zero
position properly, it may cause a large GOTO error or
even cause the scope to hit the tripod leg. The
simplest way to find the mount Zero Position of the
EQ mode is using the zero position sensors. Press
MENU=>Zero Position =>Search Zero Position, then
press ENTER. Follow the online instruction to
complete the process.
Check the online manual for AA mode Zero Position.
8. Set controller: Press the MENU button; then
“Settings”=> “Set Time & Site”.
Enter the current date. Enter the time zone offset to
the UTC; for example:
Boston is “UTC -300 minutes”
Los Angeles is “UTC -480 minutes”
2022-05-05 12:01:36
UTC -300 Minute(s)
W071d08m50s DST: Y
N42d30m32s Northern
Secondary Alt.
Lock. Lever
To Next Page
Loading...
Need help?
General
