Replacing a iPolar with a Optical Polar Scope
Tool needed: a set of metric hex key wrench and a small
Phillips screwdriver
1. Loosen two screws at the front of the mount and
two others on the top of a SkyGuider Pro main
board cover and remove the black cover.
2. Unplug the 6-wire motor driver cable and DC power
cable. Remember how wires wrapped.
3. Remove two mounting screws.
4. Gently pull the circuit board with sockets end up
and slide the circuit board out. If the board is stuck
by the motor, loosen two Phillips screws hold the
motor.
5. Remove polar scope base plate.
6. Rotate the RA axis to find TWO set screws which are
used to secure the iPolar in place. Use a 1.5mm hex
key to release the set screws. Pull the iPolar out of
the RA axle.
7. Insert optical polar scope into the RA axis. Rotate
the front camera mounting adapter to desired
orientation and adjust the polar scope so that the
LED illuminating hole is facing upward.
8. Lock polar scope via these 2 set screws.
To Next Page
Need help?
General
