iOptron iPolar - Installation Manual

iPolarInstallation–CEM60Internal(#3339A‐060)

1. Remove CEM60 polar scope cover
2. Remove the bubble level from the polar
scope by releasing two bubble level set
screws.
3. Remove polar scope illuminating LED.
Then remove three flat head screws that
secure the input panel of Cable
Management System (CMS)
4. Pull the CMS input panel so a 1.5mm allen
wrench can be inserted. Find two set
screws that separated ~90 degree from
each other on RA axle that hold the optical
polar scope. Slightly release the set screws
so the polar scope can be pulled out.
5.
Pull the polar scope out.