Section 1 Introduction
1.3c
Digital488/OEM Specifications
:$51,1*
Do not use this interface outdoors! The interface is intended for indoor use only!
Outdoor conditions could result in equipment failure, bodily injury, or death!
&$87,21
Never disassemble the interface case while it is connected to the AC power line!
Internal voltage potentials exist which could cause bodily injury or death!
Digital I/O
Transistor-Transistor Logic (TTL) Levels:
Outputs will drive 2 TTL loads.
Connector:
One 50-pin IDC, organized as two rows of 25 pins.
IEEE 488
Implementation:
SH1, AH1, T6, TE0, L4, LE0, SR1, RL0, PP0, DC1, DT1, C0, E1.
Terminators:
Selectable CR, LF, LF-CR, and CR-LF with EOI.
Programmable:
IEEE Terminators, EOI, SRQ Mask, Port Data, Active Levels, Handshake Lines, Format and Configuration.
Connector:
Standard IEEE 488 connector with metric studs.
To Next Page
Loading...