• Rotate the top cowling
• When using the machine, follow the instructions below.
6.4.3. The battery charger
IMPORTANT
Never allow the batteries to become excessively flat as this could damage them
irreparably.
6.4.4. Choosing the battery charger
Make sure the battery charge is compatible with the batteries to be charged:
tubular lead batteries: you are recommended to use an automatic battery charger.
However, you should always consult the battery charger manufacturer and manual to
confirm the choice.
gel batteries: use a charger specific for this type of battery.
6.4.5. Preparing the battery charger
If you wish to use a battery charger not provided with the machine, you must fit it with the
connector supplied with the machine.
To install the connector, proceed as follows:
• remove about 13 mm of protective sheath from the red and black wires of the battery
charger;
• insert the wires into the connector contacts and squeeze them forcefully with suitable
pliers;
• respect the polarity (red wire + black wire –) when inserting the wires into the connector.
• Insert the wired-up connector into the connector in the machine compartment.
6.5. Working
i INFORMATION
If you are using the machine for the first time, we recommend trying it on a large
obstacle-free surface first to acquire the necessary familiarity.
Starting up/use 512 – 712 RIDER:
i INFORMATION
The seat (fig. A, ref. 15) has a safety sensor which allows the machine to move only
when the operator is seated.
To Next Page
Loading...
