• Prepare the machine as described in the above paragraph.
• Lift the side brush using the lifting lever (fig. A, ref. 11).
• Turn the key switch (fig. C, ref. 1) to the "1" position.
• Check the LEDs (fig. C, ref. 5) to make sure the battery/ies is fully charged. If not,
charge the batteries (BATTERY version).
• Open the cowling and use the internal combustion engine starting handle. When the
engine is cold, you also need to use the choke (INTERNAL COMBUSTION ENGINE
with manual pull start).
• Press the internal combustion engine electric starting button (fig. A, ref. 17)
(INTERNAL COMBUSTION ENGINE with electric starting).
• Press the brush button (fig. C, ref. 3), when the brushes are active, the LED on the
button comes on. Pressing it again stops the brushes, the suction motor comes on
automatically.
• Use the accelerator knob to activate the drive (fig. A, ref. 9)
i INFORMATION
To set the maximum operating speed, proceed as follows:
1. With the machine off, turn the key switch (fig. C, ref. 1) to the "1" position.
2. Move forwards with the machine using the accelerator knob (fig. A, ref. 9) to
select the required maximum speed, then move the drive selector (fig. C, ref.
7) to the centre position. Memorising of the speed is indicated by a beep.
To reset the maximum operating speed set by the manufacturer, turn the machine
on and off using the key switch (fig. C, ref. 1) or repeat the instructions in point 2,
turning the accelerator knob (fig. A, ref. 9) as far as it will go (MAX. SPEED).
Reverse speed cannot be changed.
• Adjust pressure of the centre brush on the floor using the knob (fig. A, ref. 8) according
to the type of floor and dirt to be picked up. Turn it clockwise to increase pressure and
anticlockwise to reduce pressure on the work surface.
• Lower the side brush using the lever (fig. A, ref. 11).
• Start cleaning, manoeuvring the handgrip with the hands and acting on the drive
control.
Starting up/use 512 - 712:
• Prepare the machine as described in the above paragraph.
• Lift the side brush using the lifting lever (fig. B, ref. 11).
• Turn the key switch (fig. C, ref. 1) to the "1" position.
• Check the LEDs (fig. C, ref. 5) to make sure the battery/ies is fully charged. If not,
To Next Page
Loading...
