What to do if my IPC Eagle Floor Machine does not function?
If the IPC Eagle Floor Machine isn't functioning, there could be several reasons: * The batteries may be disconnected. In this case, connect the batteries. * The batteries may be flat. If so, recharge the batteries. * The emergency button may be pressed. If this is the case, press the emergency button.
Why is the squeegee on my IPC Eagle Floor Machine not cleaning well?
If the squeegee on your IPC Eagle Floor Machine isn't cleaning effectively, or suction is weak, consider these possibilities: * The rubber blades may be worn. If so, replace the rubber blade. * The squeegee or hose could be blocked or damaged. Clear any blockages and repair any damage. * The float switch may have tripped (collection tank full), be blocked, or be faulty. Empty the tank or repair the float. * The suction hose could be blocked. Unblock the hose. * The hose may be disconnected or damaged. Connect or repair the hose. * There may be no power to the suction motor, or the motor may be malfunctioning. Ensure the motor's power supply connector is correctly connected and the fuse is intact. If the motor is faulty, have it replaced.
How to fix brushes that won't turn on my IPC Eagle CT110 Floor Machine?
If the brushes on your IPC Eagle Floor Machine aren't turning, it could be due to several reasons: 1. The brush button may not have been pressed. Press the brush button. 2. The collection tank might be full. Empty the collection tank. 3. The brush motor fuse may have blown. Check for and remove the causes, then replace the fuse. 4. The batteries could be flat. Recharge the batteries. 5. There may be a motor malfunction. Have the motor replaced.
What to do if the suction motor on my IPC Eagle CT110 Floor Machine won't start?
If the suction motor on your IPC Eagle Floor Machine doesn't start, consider these potential causes: * The suction switch might not be activated. Activate the suction switch. * There might be no power to the suction motor, or the motor could be malfunctioning. Ensure the motor power supply connector is correctly connected to the main wiring. If the motor is faulty, have it replaced. * The fuse might be blown. Replace the fuse. * The collection tank may be full. Empty the collection tank.
Why is my IPC Eagle Floor Machine not dispensing cleaning solution?
If no cleaning solution is being delivered by your IPC Eagle Floor Machine, check these items: * The tap upstream of the filter may be closed. Open the tap. * The solution tank might be empty. Fill it. * The hose delivering the solution to the brush could be blocked. Remove the obstruction to open the hose.
Why is my IPC Eagle CT110 Floor Machine not cleaning evenly?
If your IPC Eagle Floor Machine is not cleaning evenly, it is probably because the brushes or abrasive disks are worn. Replace them.
What causes the solution flow to not stop on my IPC Eagle CT110?
If the solution flow on your IPC Eagle Floor Machine doesn't stop, it could be due to: * A dirty solenoid valve. Check the solenoid valve. * A faulty solenoid valve. Replace the solenoid valve. * Solenoid valve wiring issues. Check the solenoid valve wiring.
Why is the solution flow interrupted during operation of my IPC Eagle CT110 Floor Machine?
If the flow of solution is interrupted during operation of your IPC Eagle Floor Machine, it could be due to: * A dirty solenoid valve. Check the solenoid valve. * A faulty solenoid valve. Replace the solenoid valve. * Solenoid valve wiring issues. Check the solenoid valve wiring.
General| Model | CT110 |
|---|---|
| Category | Floor Machine |
| Voltage | 24 V |
| Solution Tank | 29 gal |
| Recovery Tank | 3 gallons |
To Next Page
