6.3. Mounting and changing the brush/abrasive disks
IMPORTANT
Never work without the brushes and abrasive disks perfectly installed.
The terms RIGHT and LEFT refer to the forward movement of the machine
Mounting the right brush (or abrasive disk)
• remove the right and left side hatches (fig. L, ref. 2);
• position the right brush (fig. M, ref. 1) under the drive disk (fig. M, ref. 2)
• lift the right brush (fig. M, ref. 1) and turn it clockwise to block it on the drive disk (fig.
M, ref. 3)
Mounting the left brush (or abrasive disk)
• Follow the same procedure as used to mount the right brush, blocking it on the drive
disk by turning it anticlockwise.
Removing the right brush (or abrasive disk)
• rotate the brush anticlockwise (fig. M, ref. 1) to release it from the drive disk (fig. M, ref.
3)
• Replace the right and left side hatches (fig. L, ref. 2);
Removing the left brush (or abrasive disk)
• Follow the same procedure as used to remove the right brush, releasing it from the
drive disk by turning it clockwise.
6.4. Detergents - Instructions
IMPORTANT
Always dilute the detergent according to the manufacturer's instructions. Do not
use sodium hypochlorite (bleach) or other oxidants, particularly in strong
concentrations. Do not use solvents or hydrocarbons. The temperature of the
water and detergent must not exceed the maximum indicated in the technical
specification. They must be free of sand and/or other impurities.
The machine has been designed for use with low-foam biodegradable detergents made
specifically for scrubber driers.
For a complete and up-to-date list of the detergents and chemicals available, contact the
Manufacturer.
Use products suitable for the floor and dirt to be removed only.
Follow the safety regulations on use of detergents given in the section "Safety
regulations".
6.5. Preparing the machine for work
IMPORTANT
Before starting work, wear overalls, ear protectors, non-slip waterproof shoes,
mask to protect the respiratory tract, gloves and all other personal protection
devices recommended by the supplier of the detergent used or necessitated by the
work environment.
Before starting work, proceed as follows:
• check the battery charge (recharge if necessary);
• make sure the collection tank (fig. B, ref. 2) is empty. If necessary, empty it;
To Next Page
Loading...
