IPC Gansow CT70 ECS - Check Detergent Fill Filter; Clean Brushes & Microfibre; Check Battery Charge; Check Detergent Output Filter

PLDC01911
Check the detergent tank fill filter is
undamaged and clean.
Check the detergent output filter is
undamaged and clean.
Clean the brush and wash the
microfibre in a washing machine.
Check the squeegee is clean and
the blades are not damaged.
Check the battery charge.
To charge, insert the battery
charger connector into the
connector alongside the
squeegee lifting lever.
REPLACING THE SQUEEGEE BLADES
• release the clip;
• remove the two blade retainers by pushing them towards the outside of the squeegee then extracting them;
• remove the blade;
• reuse the same blade by reversing the edge in contact with the floor until all four edges are worn out, or replace with
a new blade, fitting it onto the screws on the body of the squeegee;
• reposition the two blade retainers by centring the widest part of the slots over the fixing screws on the squeegee
body, then pushing the blade retainers inwards;
• fasten the clip.
AUTOMATIC BRUSH ATTACHMENT
Brush attachment, with the head raised, rest the brushes on the floor at the sides of the head. Push the brushes into the head,
making sure they are aligned with the centring devices in the head. Press the brush button. The machine attaches the brushes
automatically.
Brush release, stop the brushes and the suction motor by pressing the brush and suction motor buttons. Hold the automatic release button
down for at least five seconds and the machine releases the brushes from the head automatically.
TROUBLESHOOTING
THE MACHINE DOES NOT COME ON/START UP
CHECK THE EMERGENCY BUTTON IS NOT PRESSED
CHECK THE BATTERY CHARGE
THE SUCTION MOTOR DOES NOT WORK
CHECK THE DIRTY WATER DRUM IS NOT FULL
CHECK THE DIRTY WATER DRUM LEVEL SENSOR IS NOT
BLOCKED/MALFUNCTIONING
THE MACHINE LEAVES THE FLOOR WET
CHECK THE SQUEEGEE BLADES ARE NOT WORN
CHECK THERE IS NO DEBRIS BETWEEN THE TWO SQUEEGEE BLADES
CHECK THERE IS NO DEBRIS IN THE SUCTION HOSE
CHECK THE SUCTION FILTER IS UNDAMAGED AND CLEAN
CHECK THE DETERGENT TANK LID IS CLOSED CORRECTLY
CHECK THE SUCTION HOSE IS CORRECTLY ATTACHED TO THE SQUEEGEE
THE MACHINE LEAVES THE FLOOR DIRTY
CHECK THE TYPE OF BRUSH/PAD/MICROFIBRE IN USE IS SUITABLE FOR THE TYPE
OF DIRT AND FLOOR.
THE MACHINE LEAVES STRIPES OF WET FLOOR
CHECK THE FLOOR HAS BEEN BRUSHED BEFORE USING THE MACHINE
CHECK THERE IS NO DEBRIS BETWEEN THE TWO SQUEEGEE BLADES
CHECK THE SQUEEGEE BLADES ARE NOT WORN
CHECK THE SQUEEGEE IS CORRECTLY ADJUSTED