IPC Gansow CT110 - User Manual

Questions and Answers

M
Maria RussellAug 2, 2025
Why is my IPC Gansow CT110 squeegee not cleaning effectively?
- C
  Charles MillerAug 3, 2025
  Ineffective cleaning or suction with your IPC Gansow Scrubber's squeegee can stem from several causes: * Worn rubber blades: Replace the rubber blade if the edge in contact with the floor is worn. * Blockages or damage: Check for and remove any obstructions in the squeegee or hose, and repair any damage. * Float switch issues: Empty the collection tank if the float switch has tripped, or repair the float if it's blocked or faulty. * Suction hose blockage: Unblock the suction hose. * Hose connection problems: Connect or repair the hose if it's disconnected or damaged. * Motor issues: Ensure the motor power supply connector is correctly connected and the fuse is not blown. If the motor malfunctions, have it replaced.
I
imartinezAug 7, 2025
What to do if my IPC Gansow Scrubber suction motor does not start?
- C
  Claire HartAug 8, 2025
  If the suction motor on your IPC Gansow Scrubber isn't starting, consider these potential causes: * Suction switch: Ensure the suction switch has been activated. * Motor power: Verify the motor power supply connector is correctly connected to the main wiring. If there's a motor malfunction, have it replaced. * Fuse: Replace the fuse if it's blown. * Collection tank: Empty the collection tank if it's full.
B
Breanna NicholsonAug 13, 2025
What to do if my IPC Gansow CT110 brushes do not turn?
- R
  Ralph RodriguezAug 13, 2025
  If the brushes on your IPC Gansow Scrubber aren't turning, here's what to check: * Brush button: Make sure the brush button has been pressed. * Collection tank: Empty the collection tank if it's full. * Brush motor fuse: Check for and remove the causes of the blown fuse, then replace it. * Batteries: Recharge the batteries if they are flat. * Motor malfunction: Have the motor replaced if it's malfunctioning.
R
rgutierrezAug 17, 2025
Why is the solution flow interrupted during operation of my IPC Gansow CT110?
- J
  jriveraAug 18, 2025
  An interrupted solution flow during the operation of your IPC Gansow Scrubber may be due to: * Dirty solenoid valve: Check the solenoid valve. * Faulty solenoid valve: Replace the solenoid valve. * Solenoid valve wiring: Check the solenoid valve wiring.
D
David CoxAug 22, 2025
What to do if no solution is delivered by my IPC Gansow CT110 Scrubber?
- W
  wcopelandAug 22, 2025
  If your IPC Gansow Scrubber is not delivering any solution, consider these possibilities: * Tap position: Open the tap upstream of the filter. * Solution tank: Fill the solution tank if it's empty. * Hose blockage: Remove any obstruction to open the hose delivering the solution to the brush.
H
Heather TaylorAug 27, 2025
How to fix uneven cleaning with my IPC Gansow CT110 Scrubber?
- C
  Craig Keith DDSAug 27, 2025
  Uneven cleaning with your IPC Gansow Scrubber is likely due to worn brushes or abrasive disks. Replace them to resolve this issue.